Execute a mission

During the flight

•   Pause mode during the mission.
•   Request to land before the end of the mission.
•   Percentage of EYESEE Drone battery (Bat) and remaining flight time.
•   Location code and progress bar. Number of steps performed / Total number of steps.

Execution of a mission, in flight/case of successful barcode reading

1. The location code turns green when the code is read.
2. The read barcode appears here.
3. Indicates the number of mandatory acquisitions to be read / on the number of acquisitions read.

Execution of a mission, during the flight/case of non-reading of a code on a non-empty location

•   Pause mode during the mission.
•   Request to land before the end of the mission.
•   Gives the order to restart the flight stage.
•   Validate the system proposal and proceed to the next step.
•   Allows you to move EYESEE Drone to the left (see Parameters settings).
•   Allows you to move EYESEE Drone to the right (see Parameters settings).
•   Allows you to switch the choice of drone from NO_SCAN to EMPTY or from EMPTY to NO-SCAN.

In the case of a “mission restart” request, EYESEE Drone will automatically start reading from the first unread barcode before the mission is interrupted and then continue with the remaining mission barcodes.

The possible values are :

• « NO_SCAN » : When the location is not empty and reading is not possible (absence of the label, unreadable label etc.).
• « EMPTY » : If the location is empty.

Case of an obstacle detected under EYESEE Drone

•   Allows you to move EYESEE Drone to the left (see Parameters settings).
•   Allows you to move EYESEE Drone to the right (see Parameters settings).

In case of detection of an obstacle under EYESEE Drone the mission is stopped, and the drone remains in hover flight.

The mission cannot be resumed without a landing of EYESEE Drone. In this situation, the tablet vibrates and emits “beeps” indicating an abnormal situation.

It is the operator’s responsibility to keep a clear landing area under the drone, or move it to ensure that the drone has a cleared landing area in order to give the order to land.